Once again we come back to the polygons and will create a polygon pipe to create outside rain of the old.

Let's go in create polygon and pipe the settings are still same then it will be appear in the centre as like always either just dread a cycle on grid can drag up the high. Now you come to knew that every shape in Maya has different options. For the pipe we do have Radius and height as like we had for cylinder but this time we have a new option which is Thickness. Thickness is to make the pipe thick. As right now we just create some of the parts of the holder so we'll changed thickness, Height and Radius also as much needed.

Now create pipe and changed the imports below Radius 2, Height 6 and Thickness 0.2 and also change the Subdivisions Axis 30 and subdivision height 10.

Using the top view bring in the center of the base and then from side view or front place it on top like this

Using marking menu slept the edges, now click anywhere of one edge and pressed the keyboard right arrow key you are able to select the edge loop all around and move all outside edges like this.

Now go ahead select the down side edges and rooted them a little like the picture below.

Now use the scale tool and change reshape the object like this.

Now go back to the object now press 3 to see the object in the smooth mode you will see your object like the picture below

Be careful just Manipulate the outside edges only and also move one by one.

Now we select he faces of inside and extrude

This time open the extrude options and set the division 3 and extrude

Click on Extrude and select Scale X, Y and Z axis in channel box poly extrudeface1 and type 0.3 and press enter.

Faces extrude like this.

Now reset the Extrude settings because we changed the Divisions.

Now create an other poly pipe with the following details

Radius 2.3, Height 1.5, Thickness 0.3, Subdivisions Axis 30 and Subdivisions 8.

Now rotate and scale the edges like. Add edges form Edit Mash Insert edge loop if needed.

When you are done you will see some thing like this

Select the faces below and extrude once again.

0.85 in all X, Y and Z axis

Select the faces you just extrude and once again change the extrude divisions on 3 and extrude the like this.

Now rename the pipe to Holder ring.

<< Previous Page -- Next Page >>